HW Configuration & Connection
Videos on how to install / connect Ruptela hardware.
20 articles
FM-Tco4 LCV GPS FM tracker installation tutorial (video)
Ruptela FLS ECO fuel level sensor installation tutorial (video)
Device quick start connection guide (video)
Counting working hours using Eco4S FM tracker device (video)
OBD+LCV Solution (Video)
FM-Tco4 HCV installation using FMS harness (video)
FM-Tco4 LCV installation using OBD2 harness (video)
Towing Detection Setup in Advanced mode (Video)
Towing Detection Setup in Device Center (Video)
Custom Ignition setup in Device Center (Video)
OBD Solution Configuration (Video)
Custom Ignition Advance mode (Video)
How To Reboot The Ruptela Device (Video)
HCV5 Lite device configuration and connection with Ruptela FLS via Analog Input
LCV5 Device configuration with Sleep Timer (video)
Beacon List configuration for Wireless Trailer identification in Advanced Mode with HCV5 Lite device (video)
Tachograph Solution Configuration in Advanced Mode (video)
Custom Ignition Logic and Issues
Driver Identification via SmartphoneFor driver identification, a third-party application is required. This article describes how to use
the third-party application “nRF Connect” for driver identification. Previously, OnTrack
Connect was used, but this application…
Driver identification via BLE beacon/and/or smartphoneA smartphone can be used for driver registration. It can either serve directly as a registration source or be configured to act as a beacon. To achieve this, a third-party…