Knowledge Videos
Knowledge videos for external customer use.
39 articles
SW Configuration
Videos on how to setup up / configure Ruptela software solutions.
- Tacho App setup for Remote Tachograph Download in TrustTrack2 platform
- Admin Panel Training - Creating a New Webuser (Video)
- Admin Panel Training- Creating a New Client (Video)
- Admin panel training – Introduction (Video)
- Configuring ignition detection for FM tracker device (video)
- Enabling multiple IO parameters with few clicks (video)
- SMS generation to change device configuration (video)
- Fuel level sensor configuration and calibration (video)
- Device configuration for power cut off alert (video)
- Configuring FM tracker device for CANbus reading (video)
- Inserting calibration table to TrustTrack system (video)
- TrustTrack2 New Admin overview (video)
HW Configuration & Connection
Videos on how to install / connect Ruptela hardware.
- FM-Tco4 LCV GPS FM tracker installation tutorial (video)
- Ruptela FLS ECO fuel level sensor installation tutorial (video)
- Device quick start connection guide (video)
- Counting working hours using Eco4S FM tracker device (video)
- OBD+LCV Solution (Video)
- FM-Tco4 HCV installation using FMS harness (video)
- FM-Tco4 LCV installation using OBD2 harness (video)
- Towing Detection Setup in Advanced mode (Video)
- Towing Detection Setup in Device Center (Video)
- Custom Ignition setup in Device Center (Video)
- OBD Solution Configuration (Video)
- Custom Ignition Advance mode (Video)
- How To Reboot The Ruptela Device (Video)
- HCV5 Lite device configuration and connection with Ruptela FLS via Analog Input
- LCV5 Device configuration with Sleep Timer (video)
- Beacon List configuration for Wireless Trailer identification in Advanced Mode with HCV5 Lite device (video)
- Tachograph Solution Configuration in Advanced Mode (video)
- Custom Ignition Logic and Issues
- Driver Identification via SmartphoneFor driver identification, a third-party application is required. This article describes how to use the third-party application “nRF Connect” for driver identification. Previously, OnTrack Connect was used, but this application…
- Driver identification via BLE beacon/and/or smartphoneA smartphone can be used for driver registration. It can either serve directly as a registration source or be configured to act as a beacon. To achieve this, a third-party…
- How to configure the ignition blocking function on Eco5lite through SMSThis article describes how to activate the ignition blocking function, using the Advanced Configurator to create the equivalent SMS command.