Introduction
Omnicomm analog sensors such as the LLS-AF can be used with Ruptela devices by connecting them to an analog input (AIN). This article explains how to configure the connection.
1 Analog Input Configuration
Connect the Omnicomm sensor to one of the available analog inputs on the Ruptela device. Below is an example of the AIN1 configuration:
When connected to an analog input, the sensor must be set to "Analog" mode. The green wire of the Omnicomm sensor should be connected to the selected analog input on the Ruptela device.
⚠️ Warning: Always verify the correct wiring and pin scheme in the sensor documentation before connecting. Incorrect wiring may result in inaccurate readings.